Frame press RPN 3000


A frame press with a very sta­ble base frame made of thick-walled hol­low sec­tions, press units gal­va­nized, all com­po­nents are bolt­ed togeth­er so that the press can be set up any­where. The base frame has a high con­struc­tion, the angu­lar accu­ra­cy is guar­an­teed by cross brac­ing. The press­ing units are guid­ed by ball bear­ings and have a 50 mm pre­ci­sion hole pat­tern. The pres­sure units are stur­dy cylin­ders with 40 mm pis­ton diam­e­ter, each cylin­der has a stop­cock, the pres­sure per cylin­der is 2.5 tons and 90 mm trav­el. The press is uni­ver­sal­ly applic­a­ble for frames, pan­els, stair treads, stringers and as a car­case press. The press has a cen­tral man­u­al hydraulics and is also pos­si­ble with elec­tro­hy­draulics.

Basic equip­ment: 4 press­ing units with cen­tral hand hydraulics.



Clamp­ing dimen­sions:

h: 1600 mm x w: 2900 mm

for frames:

h: 1600 mm x w: 2600 mm

We can man­u­fac­ture any spe­cial length for you.


1x pressing unit with central hand hydraulics, pressure 2.5 t

1.102,50 €

1x central hydraulics electric, pressure 200 bar

1.438,50 €

1x hold down

294,00 €

1x swivel pressure shoe

63,00 €

1x eccentric upper clamp

210,00 €

1x shipping

388,50 €

1x side pressure device with 2 rack and pinion gears, D. 1 t

987,00 €

1x Page print set. with 2 cylinders for electr. Central hydr.

1.543,50 €

1x chassis

283,50 €

1x carcase support

115,00 €

1x miter gluing device

147,00 €

You want a special solution?